Drafts, insulation & energy rebates
Find and seal the drafts before winter, why insulation needs air sealing first, and the PSE&G programs that pay for assessments and upgrades.
Checked 2026-11-06. General information, summarized from the official sources listed. Rules, dates and products change, so check the sources before relying on them. Not professional, legal or safety advice: installs, gas and electrical work need a licensed pro and often a permit. Businesses are listed for convenience, not endorsed.
At a glance
- Air sealing is one of the cheapest upgrades for comfort and energy use, according to the U.S. Department of Energy. Insulation alone doesn't stop drafts.
- Easy leaks are DIY: caulk fixed gaps, weatherstrip doors and window sashes. Hidden attic leaks usually need a pro's blower-door test.
- Sealing a house tighter affects gas appliances: furnaces, water heaters and fireplaces need enough air, so have a pro check ventilation.
- PSE&G customers can start with a home energy assessment; income-eligible homes can get weatherization at no cost.
Find the drafts
Drafts are the obvious leaks around windows and doors, but there are often many smaller gaps you don't see: between the attic and the rooms below, where siding or brick meets the foundation, and around pipes, vents, wires and fans that pass through walls.
- On a cold, windy day, feel around window and door frames, outlets on outside walls, and the attic hatch.
- Look for dirty spots on insulation in the attic: they mark where air has been moving through.
- Check where pipes and wires enter the house, and around the dryer vent and bath fans.
U.S. Department of Energy: Do-it-yourself sealing works for obvious leaks, but not for small, hard-to-find ones, especially in attics under insulation. A certified home energy assessor finds those with a blower door test and an infrared camera. Look for certifications such as BPI Building Analyst or RESNET HERS Rater. (Source: U.S. Department of Energy)
Caulk and weatherstrip
- Caulk gaps that don't move: window and door trim, where siding meets the foundation, around pipes and wires through outside walls. Use acrylic latex for most gaps; around chimneys and flues, the Department of Energy lists high-temperature silicone.
- Spray foam fills larger gaps and holes, like around pipes in the basement.
- Weatherstripping goes where things move: around doors and between window frames and sashes. Add a door sweep at the bottom of exterior doors.
- Clean and dry the surface first, and remove old, cracked caulk.
Tip: Do it on a mild, dry fall day, and check the tube for the temperatures it needs to cure.
Sealing and safety go together
U.S. Department of Energy: Air sealing and ventilation go hand in hand. Stoves, gas furnaces, water heaters and fireplaces need enough air to burn properly; without it they can release carbon monoxide into the home. Moisture can also build up. That is one more reason the Department of Energy suggests a professional assessor or certified HVAC contractor. (Source: U.S. Department of Energy)
A job for a licensed pro. Before sealing a house much tighter, have a pro check that gas appliances vent properly. Keep working CO alarms near bedrooms (see Heating season safety).
Insulation: seal first
Insulation works like a sweater: it slows heat moving through walls and the roof. It doesn't stop moving air, which is what makes a house drafty, so seal the gaps first, then add insulation. The attic is usually the place to start, because warm air rises and escapes there.
A job for a licensed pro. Adding attic or wall insulation, and sealing the attic floor, is usually a contractor job. An energy assessment report lists which upgrades pay off most in your house.
Assessments, rebates and help paying
Tenafly homes are PSE&G customers for electricity and gas. PSE&G's energy programs list:
- Whole home energy assessment: expert advice and upgrades, from a basic assessment to a full one by a contractor.
- Home Weatherization (income-eligible): a free assessment plus efficiency, health and safety upgrades at no charge.
- Comfort Partners (income-eligible): a free program, run with the state's Clean Energy Program, that installs measures to lower bills.
- On-bill repayment: pay for upgrades in equal, interest-free installments on your PSE&G bill, up to a limit PSE&G sets.
- HVAC instant rebates on eligible heating, cooling and water heating equipment through participating contractors.
PSE&G: Eligibility, amounts and the list of participating contractors are on PSE&G's program site, and they change. Check there before you sign a contract. (Source: PSE&G)
PSE&G also has a free online "Home Energy Snapshot" that shows how your home uses energy. The state's Clean Energy Program lists contractors and the Comfort Partners program.
Tenafly businesses
Home maintenance in Tenafly. Listed A–Z for convenience, not endorsed.
- North Jersey Home Maintenance Group: Handyman: caulking and home repairs